Tel: 0808 123 1214 Tel: 07780808282
Tel: 0808 123 1214
Tel: 07780808282
Fully biodegradable
Does not bio-accumulate
Ph neutral, so safe for materials and gentle on people
Controls algae, lichen, fungi, moss and mould
Safe for children and pets once treated surface is completely
dry
Non-bleaching (contain no bleach or acids)
Harmless to all known building materials
Can be used as a pre-painting primer to kill algae and mould
spores
Soaks deep into porous surfaces – killing the micro-
organisms responsible for unsightly discolouring, and
potential structural damage
Pressure Washing at a high pressure is not recommended to clean wall as the force of the jet will dislodge the dash. Softwashing is the preferred method for the cleaning of Pebble Dash and Roughcast this non-invasive system uses chemicals to remove the staining
rather than force.
Cleaning & Treating the biofilm with a Softwash System
2) A Biocidal Wash (DDAC) fully biodegradable does not bio-accumulate Ph neutral, so safe for children and pets once treated surface is completely dry.
The Softwash Solution:
Cleans – Sanitises – Disinfects
The products active ingredient is recommended for the
cleaning of – render and cladding – of industry-leading
companies such as K Rend, Weber and Kingspan Cladding.
Effective and safe to use on:
o
Coloured and plain wall render
o
Concrete patios & paths
o
Painted surfaces
o
Timber decking
o
Natural stone, including sandstone and granite
The Softwash Solution:
1) A hypochlorite based softwash biocide which at 5:1-10:1 dilution is classed by the EU, PCD and HSE as non corrosive or hazardous to people or the environment. This solution contains no acids or solvents does not bio-accumulate and the surfactant is fully
biodegradable and after use it quickly breaks down into tiny amounts of ordinary salt and water
Roughcast is a common decorative finish on many exterior houses. The cast over time captures small dirt particles this allows bacterial growth to establish which appears as red, green or black staining. This staining is more obvious on the walls that take the brunt
of the weather but can be on all walls. The biofilm staining can be removed from the wall using our Softwash systems.
Before
After
Before
After
Results can take up to 1 year to cleanse the wall
The render can be treated using our professional softwash products which are fully approved by both the Irish Pesticides Registration & Control Service (PCS) and UK Health & Safety Executive (HSE) for use as a softwashing biocide in Ireland and the UK also it's
fully compliant with the EU "REACH" (Registration, Evaluation, Authorisation & restriction of Chemicals) regulations for cleaning exterior hard surfaces.
This professional grade product can give outstanding results as can be seen in the photos. A safe and effect method to return your property to that new look again. We are an experienced Softwash applicators with all the professional up to date equipment to give a
quality finish every time.
Roughcast Cleaning Motherwell
Roughcast Cleaning (results can be achieved the same day for some works)
The surrounds of doors and windows can be made from cast stone which is made from Natural Aggregates, Cementitious Binder and Pigments but over time grime builds up on the surface and need to be cleaned.
High Pressure washing can damage natural stone or cast stone and is best avoided Softwashing is the preferred method for cleaning but super-heated water at very low pressure can also be used. The Softwash system we use can not only clean the stone but
can have residual benefits.
Cast Stone Cleaning
Cast Stone Cleaning
Cast Stone Cleaning
The build-up of moss, lichen and built-up dirt must be removed normally with a soft bristle brush.
The Softwash is then applied to the surface area left to dwell before being rinsed the procedure
may need to be carried out more than once. This can be follow with an inhibitor treatment.
Before
After
Roughcast Cleaning Motherwell
Roughcast Cleaning Motherwell
Fully biodegradable
Does not bio-accumulate
Ph neutral, so safe for materials and gentle on people
Controls algae, lichen, fungi, moss and mould
Safe for children and pets once treated surface is
completely dry
Non-bleaching (contain no bleach or acids)
Harmless to all known building materials
Can be used as a pre-painting primer to kill algae and
mould spores
Soaks deep into porous surfaces – killing the micro-
organisms responsible for unsightly discolouring, and
potential structural damage
The application of a Softwash Solution via a very low
pressure nozzle and pump. The Softwash solution is
sprayed onto the wall or in some instances it is
brushed on.
System 1: The hypochlorite solution is sprayed onto
the wall and then left for 30-60 minutes before being
rinsed of. It may require more than 1 treatment to bring
the walls up to an acceptable standard. The final step
of the process is to treat the wall with the inhibitor
solution. Results are normally seen within 3-24 hours
of application.
System 2: The application of a (DDAC) solution. The
wall is saturated with the solution which is not rinsed
off but just left to dry. This system can take up to 1
year to fully clean but some noticeable difference
should be seen within a few months.
Pressure Washing at a high pressure is not
recommended to clean wall as the force of the jet will
dislodge the dash. Softwashing is the preferred
method for the cleaning of Pebble Dash and
Roughcast this non-invasive system uses chemicals to
remove the staining rather than force.
Cleaning & Treating the biofilm with a
Softwash System
System Application How to clean
Render Walls
2) A Biocidal Wash (DDAC) fully biodegradable does
not bio-accumulate Ph neutral, so safe for children and
pets once treated surface is completely dry.
The Softwash Solution:
Cleans – Sanitises – Disinfects
The products active ingredient is recommended for the
cleaning of – render and cladding – of industry-leading
companies such as K Rend, Weber and Kingspan
Cladding.
Effective and safe to use on:
o
Coloured and plain wall render
o
Concrete patios & paths
o
Painted surfaces
o
Timber decking
o
Natural stone, including sandstone and granite
The Softwash Solution:
1) A hypochlorite based softwash biocide which at 5:1-
10:1 dilution is classed by the EU, PCD and HSE as
non corrosive or hazardous to people or the
environment. This solution contains no acids or
solvents does not bio-accumulate and the surfactant is
fully biodegradable and after use it quickly breaks
down into tiny amounts of ordinary salt and water
Roughcast is a common decorative finish on many
exterior houses. The cast over time captures small dirt
particles this allows bacterial growth to establish which
appears as red, green or black staining. This staining is
more obvious on the walls that take the brunt of the
weather but can be on all walls. The biofilm staining
can be removed from the wall using our Softwash
systems.
Before
After
Before
After
Results can take up to 1 year to cleanse the wall
Cast Stone Cleaning
The surrounds of doors and windows can be made
from cast stone which is made from Natural
Aggregates, Cementitious Binder and Pigments but
over time grime builds up on the surface and need to
be cleaned.
High Pressure washing can damage natural stone or
cast stone and is best avoided Softwashing is the
preferred method for cleaning but super-heated water
at very low pressure can also be used. The Softwash
system we use can not only clean the stone but can
have residual benefits.
Cast Stone Cleaning
The build-up of moss, lichen and built-up dirt must be
removed normally with a soft bristle brush. The
Softwash is then applied to the surface area left to
dwell before being rinsed the procedure may need to
be carried out more than once. This is followed with
an inhibitor treatment.
Roughcast Cleaning Motherwell
Tel: 0808 123 1214
Mob: 07780808282
